For further questions and technical issues, do not hesitate to contact us via our mailbox: support@kvapileng.com
- Install SimHub software
- Install drivers for USB communication
- Load the profiles into SimHub software
DOWNLOAD SECTION
Profiles for SimHub
Settings for reflashing the device – not needed, only for troubleshooting!
LOADING PROFILES INTO THE SIMHUB
- Select „Arduino“ on the left side
- Select „Profiles manager“
- Select „Import profile“, find the downloaded profile in the browser
- Click „Load“
TROUBLESHOOTING
DEVICE IS NOT SHOWING UP IN THE SIMHUB
- Disconnect and then reconnect the device
- Try a different USB cable
- Try a different USB port on your computer
- Restart SimHub software
- Restart the computer
- Reinstall CH340 driver
RGB MATRIX IS ROTATED
In „Arduino“ -„My Hardware“ open the device using the arrow, select „Portrait (180°)“ and click on the blue button „Apply changes“.
REFLASING THE DEVICE
In „Arduino“ – „My Hardware“ click on „Open arduino setup tool“, then in the new window click on „Start from skretch“. In the top menu, click on „Profiles“, then on „Load profile“ button. Select the downloaded .tfp file from the browser. On the right side, select Board – „Arduino Nano (ATMega328), new bootloader“ and select COM port of the device. Check the checkbox and press „UPLOAD TO ARDUINO“. When the process is done, disconnect the device from computer, restart SimHub and it should properly show in the „My Hardware“ tab.